Setup to Enable or Disable CNF for a Cisco Unified CM Cluster¶
The following steps are a checklist to enable change notification for a Cisco Unified CM cluster in VOSS Automate.
Ensure the Service is enabled and configured in Cisco Unified CM. (Cisco Unified CM Setup to use CNF )
Enable Change Notification on the Cisco Unified CM cluster in VOSS Automate. (VOSS Automate Change Notification Functionality)
Review the detailed Change Notification settings for the cluster. (VOSS Automate Change Notification Functionality)
Review or create the required Data Sync instances for change notification for the cluster. Refer to the topics on Data Sync following Introduction to Data Sync.
The number of syncs and their setup will depend on the needs for your system and the design.
See the Best Practices Guide for guidance on sync logic and recommended setups. If further recommendations or guidance is needed, contact your VOSS account team or VOSS support.
Review or create required schedules for the Data sync(s) created above and activate the schedule(s). (Enable a Scheduled Data Sync)
Follow the guidance for scheduling around syncs to ensure the load on the system is optimized. At least one sync schedule should be activated for the CNF setup to be complete.
Follow the steps in reverse in order to disable change notification for the cluster.