Enable a Scheduled Data Sync¶
This procedure enables the scheduled data sync so that it executes regularly.
Note
Setting up a CUCM or CUC device in VOSS Automate …
Creates a full pull data sync instance, which will perform the initial sync of all data from the device. It is recommended that you manually run the full pull data sync only when necessary. See Manually Run the Default Data Sync
Creates a Change Notification Sync type (on the Data Sync page). Manually running the change notification sync is not supported.
Creates a scheduled data sync (disabled by default) to execute a data sync every 14 days. This topic describes how to enable this regular sync.
Enable the scheuled data sync
Log in as provider administrator.
Go to (default menus) Administration Tools > Scheduling.
On the Scheduling page, choose the schedule instance that matches this naming convention:
HcsSync-<ip_address>-<device_name>-SCHED. For example:
HcsSync-192.0.2.24-CUCM01-SCHED
Select the Active check box.
Select the Multiple Executions tab, and update the interval, as required.
Click Save.
The full data sync executes immediately, and executes again according to the schedule.