Configure Tail End Hop Off#

Note

The following task is applicable only if you are using VOSS Automate 10.6(2) or later.

Follow these steps to manually configure Tail End Hop Off (TEHO) in Cisco Unified CDM:

  1. Configure route-group:

    1. Select the hierarchy up to customer level. For procedures, see Configure Route Groups.

    Note

    While adding a new route group, enter a name and then select the sip_trunk added to the remote LBO site (for example, RouteGroup: TEHO-RG, Device: L1LBO-SIP).

  2. Configure route-list:

    Select the hierarchy up to customer level. For procedures, see Configure Route Lists.

    Note

    While adding a new route list, enter a name and then add three route groups (for example, RoutList: TEHO-RL, 1stRouteGroup: TEHO-RG, 2ndRouteGroup: SLRG-Natl, 3rdRouteGroup: RG-AGGR).

  3. Configure route-pattern:

    1. Log in as Provider or Reseller Administrator.

    2. Select the hierarchy up to customer level.

    3. Select Device Management > CUCM > Route Patterns.

    4. Click the Route Pattern from the list.

    5. Go to Action, and then click Clone.

    6. In the Pattern Definition tab, select the CUCM.

    7. Edit the Route Pattern name.

    8. Select the Route List that is configured when configuring the route list for TEHO (for example, RoutePattern: **[0-3]0[236-9]1.608!, RouteList: TEHO-RL). In this route pattern, 608 is the area code for the remote location).