Enabling / Disabling CNF Syncs for a CUCM cluster#

This section describes the high level steps for enabling change notification (CNF) syncs for a Cisco Unified Communications Manager (CUCM) cluster in VOSS Automate:

Note

Perform these steps in reverse order to disable change notification for the cluster.

  1. Enable and configure the service in CUCM - see CUCM Setup to use CNF

  2. Enable change notification on the CUCM cluster in VOSS Automate - see VOSS Automate Change Notification Functionality

  3. Review the change notification settings for the cluster - see VOSS Automate Change Notification Functionality

  4. Review or create the required data sync instances for change notification, for the cluster - see the topics on data sync, from Introduction to Data Sync.

    Note

    The actual number of syncs and their setup will depend on the needs for your system and the design.

    See the Best Practices Guide for guidance on sync logic and recommended setups. If further recommendations or guidance is needed, contact your VOSS account team or VOSS support.

  5. Review or create required schedules for the data sync(s) created in the previous step, and activate the schedule(s) - see Enable a Scheduled Data Sync

    Note

    Follow the guidance for scheduling around syncs to ensure the load on the system is optimized.

    At least one sync schedule should be activated for the CNF sync setup to be complete.