Set up Arbitrator to Arbitrator Communication

Log in as admin on the central/lead arbitrator and go to VPN Server Configuration

39107c6e2431b9a8

Then Clear Fabric Configuration, then reset this up:

  1. Set the Organization name

  2. Set The Public Ip Address ( this is the address of the Arbitrator)

  3. Set Authorized Client Port to 62003

  4. Set the Negotiation Port to 62004

  5. Set the VPN Subnet (to a number between 1 and 150)

  6. Set the Ethernet Interface Number (Usually 0)

As shown in the example below:

3a9ca777562d8051

On the subordinate Arbitrator log in as admin and navigate to VPN Client Configuration

2063e66e68f310b6

  1. Clear Fabric Configuration to remove any remnants of other tunnels

  2. Then set the Server Address as the IP address of the Central/Lead Arbitrator

  3. Ensure the Negotiation Port is set as 62004

  4. Click Done.

A Tunnel will now be set up between the Arbitrators.

You can check this by running the following commands in CLI when logged in as root:

3c9430d190b62263

The tunnel is setup using 169.253.x.x addresses:

108814a1881510c1

To set Alerts to be forwarded from the subordinate Arbitrators to the Central/Lead Arbitrator:

  • On the Subordinate Arbitrator go to Response Procedures in the config area of the GUI:

    590cdf6a9454d348