Set up Arbitrator to Arbitrator Communication
-----------------------------------------------


Log in as admin on the central/lead arbitrator and go to VPN Server
Configuration

|39107c6e2431b9a8|

Then Clear Fabric Configuration, then reset this up:

a. Set the Organization name
b. Set The Public Ip Address ( this is the address of the Arbitrator)
#. Set Authorized Client Port to 62003
#. Set the Negotiation Port to 62004
#. Set the VPN Subnet (to a number between 1 and 150)
#. Set the Ethernet Interface Number (Usually 0)

 As shown in the example below:

|3a9ca777562d8051|



On the subordinate Arbitrator log in as admin and navigate to VPN Client
Configuration

|2063e66e68f310b6|

1. Clear Fabric Configuration to remove any remnants of other tunnels
2. Then set the Server Address as the IP address of the Central/Lead
   Arbitrator
3. Ensure the Negotiation Port is set as ``62004``
4. Click **Done**.

A Tunnel will now be set up between the Arbitrators.

You can check this by running the following commands in CLI when logged in
as root:

|3c9430d190b62263|

The tunnel is setup using ``169.253.x.x`` addresses:

|108814a1881510c1|

To set Alerts to be forwarded from the subordinate Arbitrators to the
Central/Lead Arbitrator:

* On the Subordinate Arbitrator go to Response Procedures in the config area
  of the GUI:

  |590cdf6a9454d348|



.. |39107c6e2431b9a8| image:: /src/images/39107c6e2431b9a8.png
.. |3a9ca777562d8051| image:: /src/images/3a9ca777562d8051.png
.. |2063e66e68f310b6| image:: /src/images/2063e66e68f310b6.png
.. |3c9430d190b62263| image:: /src/images/3c9430d190b62263.png
.. |108814a1881510c1| image:: /src/images/108814a1881510c1.png
.. |590cdf6a9454d348| image:: /src/images/590cdf6a9454d348.png