How to configure a Cisco ISR router to send NetFlow v5 data to VOSS Insights Arbitrator#

Abstract#

This document provides the procedure to configure a Cisco ISR router to send NetFlow data to VOSS Insights Arbitrator using v5 format.

Assumptions#

This document assumes that the following configuration will be applied on a Cisco ISR router with two interfaces:

  • GigabitEthernet0/0/0

  • GigabitEthernet0/0/1

For the purposes of this guide, the following software specifications are assumed:

isr4300-3977#show version
Cisco IOS XE Software, Version 03.16.04b.S - Extended Support Release
Cisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M),
Version
15.5(3)S4b, RELEASE SOFTWARE (fc1)

VOSS Insights Team recommends that Netflow is configured and enabled in the “ingress” direction for all interfaces on a Netflow source device.

Configuration#

The following sample configuration can be used as a template for Netflow v5:

ENABLE SNMP INDEX PERSISTENCE

isr4300-3977#configure terminal

Enter configuration commands, one per line. End with CTRL-Z.

isr4300-3977(config)#snmp-server ifindex persist
isr4300-3977(config)#

NETFLOW CONFIGURATION

isr4300-3977(config)#flow exporter lxexporter-1

destination [VOSS Insights Arbitrator IP Address]

export-protocol netflow-v5

transport udp [Netflow Collector Port]

exit

isr4300-3977(config)#flow monitor lx-flowmonitor-1

record netflow ipv4 original-input

exporter lxexporter-1

exit

isr4300-3977(config)#ip cef distributed

isr4300-3977(config)#interface GigabitEthernet0/0/0

ip flow monitor lx-flowmonitor-1 input

exit

isr4300-3977(config)#interface GigabitEthernet0/0/0

ip flow monitor lx-flowmonitor-1 output

exit

isr4300-3977(config)#exit

#copy run start

Note

Please note that VOSS Insights Arbitrator uses UDP 9996 to receive NetFlow v5 by default.