.. _filtering_sub-transactions_and_logs:

Filtering Sub-Transactions and Logs
-----------------------------------

Some transactions have sub-transactions as well as a log list on the transaction
detail view. The filtering of sub-transactions and logs works like the list view
filter, in other words, a range of matching operators are available.

If a sub-transaction has further sub-transactions, click the Link in its Transaction
column to carry out any filtering on nested sub-transactions. To navigate up the
sub-transaction hierarchy, click the parent Link.

* In the Admin Portal, sub-transaction lists can be filtered by entering the filter value in the column
  header filter boxes of the list:

  * **Id**
  * **Action**
  * **Status**
  * **Submitted Time**
  * **Detail**

  More than one filter can be added - this will result in a logical AND of the filters.
  Filter values are matched case-insensitive and with match operator CONTAINS.
  To clear a filter, click the "x" in the column header filter box.

* In the Legacy Admin GUI, use the **Filter** button below the list of sub-transactions
  to add a filter in the pop up form. The following columns can be filtered:

  * **Action**
  * **Status**
  * **Detail**

  The following match operators are available: Contains, Does Not Contain, Starts With, Ends With,
  Equals, Not Equal. In addition, an **Ignore Case Value** check box is available to apply to each value.
  Multiple filters will result in a logical AND of the filters. When a filter is applied to a list,
  an "X" will show next to the **Filter** button to clear the filter.

   
The log columns to filter by, are:

* Severity
* Message
* Duration (some logs - only equals and not equals)

For more details on matching operators when filtering sub-transactions and logs, also refer
to "Filtering Lists".