Configure Tail End Hop Off
--------------------------

.. note::

   The following task is applicable only if you are using VOSS Automate
   10.6(2) or later.                       

Follow these steps to manually configure Tail End Hop Off (TEHO) in Cisco Unified CDM:


1. Configure route-group:

   a. Select the hierarchy up to customer level. For procedures, see Configure
      Route Groups.

   .. note::

      While adding a new route group, enter a name and then select the sip_trunk
      added to the remote LBO site (for example, RouteGroup: TEHO-RG, Device: L1LBO-SIP).
      
2. Configure route-list:

   Select the hierarchy up to customer level. For procedures, see Configure Route
   Lists.

   .. note::

      While adding a new route list, enter a name and then add three route groups
      (for example, RoutList: TEHO-RL, 1stRouteGroup: TEHO-RG, 2ndRouteGroup:
      SLRG-Natl, 3rdRouteGroup: RG-AGGR).
      
3. Configure route-pattern:                                  

   a. Log in as Provider or Reseller Administrator.
   b. Select the hierarchy up to customer level.
   c. Select **Device Management > CUCM > Route Patterns**.
   d. Click the Route Pattern from the list.
   e. Go to Action, and then click **Clone**.
   f. In the **Pattern Definition** tab, select the CUCM.
   g. Edit the Route Pattern name.
   h. Select the Route List that is configured when configuring the route list for
      TEHO (for example, RoutePattern: \**[0-3]0[236-9]1.608!, RouteList: TEHO-RL).
      In this route pattern, 608 is the area code for the remote location).