Dial Plan Example Workflow
--------------------------

Dial plan procedures available in VOSS Automate are found in this section. However,
additional procedures and more detailed information about dial plans can be found
in the "Provider HCS Dial Plan Management Support Guide".


**Perform these steps**:

1. Optionally, deploy country dials plans for countries other than United
   States or United Kingdom. See the "Provider HCS Dial Plan Management Support Guide".

   If you are using country dial plans other than US or UK, you must complete this
   step before continuing to the next step.
   
2. Apply customer dial plan at customer.
3. Apply site dial plan at site.
4. Optionally, configure Class of Service at site.
5. Add Directory Number Inventory at customer or site.
6. Optionally, configure E.164 Inventory at customer or site.
7. Optionally, configure E.164 Number to Directory Number associations at
   customer or site.
8. If not using Site Location Codes (that is, you have deployed a Type 4 Dial Plan),
   configure Directory Number Routing at site to enable intra- and inter-site calls.
9. Optional, configure Short Codes at site.
10. Edit Site Defaults as follows:

    a. On the **Device Defaults** tab, set the Default VOSS Automate Device CSS to
       an appropriate device Class of Service.
    b. On the **Line Defaults** tab, set the Default CUCM Line CSS to an
       appropriate line Class of Service.
       
11. For offnet PSTN call configuration, see the "Provider HCS Dial Plan Management Support Guide".
12. For Local Breakout (LBO) configuration, see "IOS Device Management".
13. For user, phone, and line configuration, see "Subscriber Management".